Trooper LS V6-3.5L (1998)
Be sure to discard used parts, and always use new parts for installation. Prior to installation, lubricate all seals and rings with power steering fluid.
REASSEMBLY
1. Install rear housing.
2. Install pin.
3. Install cam.
4. Install the rotor with punch mark facing the front housing.
5. Install the vanes with curved face in contact with the inner wall of the cam.
6. Install side plate.
CAUTION: When installing side plate, be careful not to damage its inner surface. Damaged side plate may cause poor pump performance, pump
seizure or oil leakage.
7. Install front housing.
8. Install a new o-ring and be sure to discard used parts.
9. Install a new o-ring and be sure to discard used parts.
10. Install a new gasket and be sure to discard used parts.
11. Install rear housing and pump cartridge.
12. Install bolt and tighten it to the specified torque.
Torque: 17.6 Nm (12.8 ft. lbs.)
13. Install a new oil seal and be sure to discard used parts.
CAUTION: When installing the oil seal, be careful not to damage the oil seal contacting surface of the housing.
14. Install shaft assembly.
15. Install snap ring.
16. Install spring.
17. Install retaining ring.
18. Install filter.
19. Install valve.
20. Install retaining ring.
21. Install a new o-ring and be sure to discard used parts.
22. Install connector and tighten it to the specified torque.
Torque: 19.6 Nm (14.3 ft. lbs.)
23. Install a new o-ring and be sure to discard used parts.
