Trooper LS V6-3.5L (1998)
INSPECTION AND REPAIR
Make necessary correction or parts replacement if wear, damage, corrosion or any other abnormal conditions are found through inspection. Check the
following parts:
-
Lower control arm
-
Bushing
INSTALLATION
1. Install rear bushing by using installer J-36834.
2. Install front bushing by using installer J-36833.
3. Install lower ball joint bolt.
4. Install torsion bar arm bolt.
5. Install lower control arm.
6. Install rear bolt.
7. Install front bolt.
8. Install lower ball joint and tighten it to the specified torque.
Torque: 103 Nm (76 ft. lbs.)
9. Install shock absorber and tighten it to the specified torque.
Torque: 82 Nm (61 ft. lbs.)
10. Install stabilizer link and tighten it to the specified torque.