Trooper LS V6-3.5L (1998)
16. Remove seal ring.
17. Remove plate.
18. Remove bolt and nut.
INSPECTION AND REPAIR
Make the necessary adjustments, repair, and part replacements if excessive wear or damage is discovered during inspection.
Cylinder Body
1. Clean the cylinder body.
2. Check the fluid return port for restrictions and clean it if necessary.
Inner Parts
1. Visually inspect the disassembled parts for excessive wear and damage.
2. Replace the inner parts with new parts shown in the illustration.
3. Measure the clearance between master cylinder wall and piston.
4. If the measured value exceeds the specified limit, the master cylinder assembly must be replaced.
Standard: 0.07 mm (0.0028 inch)
Limit: 0.15 mm (0.0059 inch)
REASSEMBLY
To reassemble, follow the disassembly steps in the reverse order, noting the following points: