Trooper LS V6-3.5L (1998)
Limit: 0.5 mm (0.02 inch)
NOTE: Do not heat the shaft to correct its bend.
Inner Shaft Bearing
1. Inspect the state of inner shaft bearing. If any abnormality such as roughness is found, replace with a new inner shaft bearing.
2. Insert a clutch gear and check the state of needle bearing.
3. If there is an abnormality such as roughness, replace the needle bearing.
Sleeve Condition
Check and see that there is no wear, damage, or cracking in the sleeve.
NOTE: Close inspection of the groove and inner gear are required because those are important parts.
Sleeve Function
Operate the sleeve with the inner shaft combined with the clutch gear. If roughness is felt, replace the sleeve.
NOTE: Gear oil should be applied to the contact surface of gear.