Trooper LS V6-3.5L (1998)
-
Remove the bushings using a remover J-39378-1 and hammer.
-
By using installer J-39378-2 and base J-39378-3, press fit the bushings into the bracket.
REASSEMBLY
1. Install DOJ case to bracket.
2. Install oil seal and fix snap ring.
3. Install bearing and fix snap ring.
4. Install bracket to axle case. Tighten the bracket bolt to the specified torque.
Torque: 116 Nm (85 ft. lbs.)
5. Apply 150g of the specified grease in BJ.
6. Install dust seal.
7. Apply a thin coat of grease to the shaft for smooth installation then install bellows.
8. Install band. Note the setting direction. After installation, check that the bellows is free from distortion.
9. Install another bellows and fix band.
10. Install the ball guide with the smaller diameter side ahead onto the shaft.
11. Install ball retainer.
