Trooper LS 2WD V6-3.5L (2001)
Sensing And Diagnostic Module: Service and Repair
Removal
1. Disable the SRS.
2. Remove the transmission knob (for M/T) and transfer lever knob.
3. Remove the front console assembly and disconnect wiring harness connector.
4. Pull CPA (Connector Position Assurance) out and push connector lock down to disconnect the SDM harness connector.
5. Remove the three SDM fixing bolts and remove SDM.
Installation
1. Install the SDM on bracket and fixing bolts and tighten the fixing bolts to the specified torque.
Torque: 10 Nm (87 lb in)
2. Connect the SDM harness connector and after that, put CPA into connector.
3. Install the front con sole.
4. Install the transmission knob (for M/T) and transfer lever knob.
5. Enable the SRS.
