Trooper LTD V6-3165cc 3.2L SOHC MFI (6VD1) (1997)
^
Insert the piston/connecting rod assemblies into each cylinder with the piston ring compressor. The front marks must be facing the front of the
engine.
^
Match the numbered caps with the numbers on the connecting rods. Align the punched marks on the connecting rods and caps.
^
Apply engine oil to the threads and seating faces of the nuts. Tighten the nuts to 54 Nm (40 ft. lbs.).
^
After tightening the cap nuts, check to see that the crankshaft rotates smoothly.
6. Oil gallery [7]
^
Tighten the bolts in 2 steps, in the order shown.
^
First tighten to 29 Nm (22 ft. lbs.)
^
Second tighten 55°-65°
7. Crankcase side bolts [6]
^
Tighten all the bolts to 39 Nm (29 ft. lbs.) in the order shown.
NOTE: Do not apply engine oil to the crank case side bolts.
8. Oil pump assembly [5]
9. Oil strainer and rubber ring [4]
10. Oil pipe and rubber ring [3]
^
Tighten the bolts to 19 Nm (14 ft. lbs.).