Trooper LTD V6-3165cc 3.2L SOHC MFI (6VD1) (1997)
REMOVAL
NOTE:
^
Remove battery negative cable.
^
Raise the vehicle and support with suitable safety stands.
1. Transfer under cover
2. 3rd crossmember
3. Front propeller shaft
4. Oxygen (02) sensor harness connector
^
Disconnect front 02 sensor harness connector and rear 02 sensor harness connector.
5. Three way catalytic converter
^
Remove three fixing nuts at exhaust manifold.
INSTALLATION
^
To install follow the removal steps in the reverse order, noting the following points.
^
Tighten the 3rd crossmember bolts and nuts to 50 Nm (37 ft. lbs.).
^
Tighten the transfer under cover bolts to 46 Nm (34 ft. lbs.).
^
Tighten the front propeller shaft bolts to 63 Nm (46 ft. lbs.).
^
Three way catalytic converter fixing nuts:
-
Exhaust manifold side 67 Nm (49 ft. lbs.).
-
Muffler side 43 Nm (32 ft. lbs.).