Trooper LTD V6-3165cc 3.2L SOHC MFI (6VD1) (1997)
Air Door: Service and Repair
Heater Mode Control Link Unit
Preparation:
Disconnect the battery ground cable
Drain engine coolant
1. Heater unit
-
Refer to HEATER UNIT" removal procedure.
2. Case (Mode control)
-
Remove the case (Mode control) from heater unit.
3. Washer and mode main lever
4. Rod
5. Mode sub-lever
-
Press the tab of the sub-lever inward, and take out the sub-lever.
6. Door lever
-
Pull out the door lever while raising up the catch of the door lever.
7. Clip
INSTALLATION
To install, follow the removal steps in the reverse order, noting the following points:
1. Apply grease to mode sub-lever and to the abrasive surface of the heater unit.
2. After installing the link unit, check to see if the link unit operates correctly.