Trooper S 2WD V6-3.5L (2001)
18. Disconnect the starter switch harness connector located base of steering column.
19. Remove steering lock cylinder assembly.
20. Apply a setting mark across the universal joint and steering shaft to reassemble the parts in their original position.
21. Remove steering column assembly.
Installation
1. Install the steering column assembly and align the setting marks on the universal joint and steering shaft made during removal.
2. Tighten the steering column fixing bolts (dash panel side) to the specified torque.
Torque: 20 Nm (14 lb ft)
3. Tighten the steering column fixing bolts (Pedal bracket) to the specified torque.
Torque: 20 Nm (14 lb ft)
4. Tighten the universal joint to the specified torque.
Torque: 31 Nm (23 lb ft)
5. Install steering lock cylinder assembly.
6. Connect shift lock cable (For A/T)
7. Install cushion rubber.
8. Install snap ring.
9. Install the combination switch assembly with SRS coil.
10. Connect the wiring harness connector located on the base of steering column.
