Trooper S 4WD V6-3.5L (2002)
2) Check the pole piece for damage, and replace the speed sensor if necessary.
3) Check the speed sensor cable for a short or an open, and replace with a new one if necessary. To check for cable short or open, bend or stretch the
cable while checking for continuity.
4) Check the sensor ring for damage including tooth chipping. If damaged replace the axle shaft assembly.
Installation
1) Install the speed sensor and take care not to hit the speed sensor pole piece during installation.
2) Install the sensor fixing bolt and tighten it to the specified torque.
Torque: 18 Nm (13 ft. lbs.)
3) Install the sensor cable fixing bolt and tighten it to the specified torque.
Torque: 24 Nm (18 ft. lbs.)
Note: Confirm that the cable is not twisted when connecting the speed sensor cable.
4) Install clip.
5) Install speed sensor connector.
