Trooper S 4WD V6-3.5L (2002)
Wiper Arm: Service and Repair
Rear Wiper Arm/Blade
Rear Wiper Arm/Blade
Removal
1. Remove the arm nut (2).
2. Remove the wiper arm/blade (1).
Installation
To install, follow the removal steps in the reverse order, noting the following points.
1. Before installing the wiper arm/blade to the motor shaft, confirm that the motor stops at the auto-stop position.
2. Install the wiper arm so that the blade gets parallel to the lowermost heat wire (2) of the rear defogger (w/ rear defogger), or position the blade 20
mm (0.79 in) from edge of tailgate glass (W/O rear defogger).
3. Tighten the motor shaft nut to the specified torque.
Torque: 6 N.m (52 lb in)
4. Tighten the wiper arm nut to the specified torque.
