VehiCROSS 4WD V6-3.5L (1999)
Parking Brake Cable: Service and Repair
Removal
1. Remove adjusting nut.
2. Remove rear wheels.
3. Remove caliper assembly, remove two bolts to remove the caliper assembly from the support bracket. Temporarily hang the caliper with a wire in
order to avoid stretching the brake hose.
4. Remove rotor (drum).
5. Remove clip (floor side).
6. Remove bolt.
7. Remove back plate.
8. Remove clip (frame side).
9. Remove clip (suspension side).
10. Remove holding spring.
11. Remove return spring; upper.
12. Remove return spring; lower.
13. Remove the brake shoe assembly. Then remove the parking brake cable from the parking brake lever (1)
14. Remove cable fixing bolt.
15. Remove rear cable.
Installation
To install, follow the removal steps in the reverse order, noting the following points:
1. Install rear cable and apply grease (BESCO L-2 or equivalent) to the connecting portion of the rear cable and the equalizer.
2. Install cable fixing bolt and tighten the cable fixing bolt to the specified torque.
Torque: 6 Nm (52 inch lbs.)
3. Install shoe assembly and after installation of the shoe and cable assembly, apply the special grease included in the repair kit to the portions
indicated in the illustration.
4. Install return spring; lower.
