VehiCROSS 4WD V6-3.5L (1999)
Parking Brake Lever: Service and Repair
Removal
1. Remove adjusting nut (3).
2. Remove equalizer (4).
3. Remove center console.
4. Remove bolts.
5. Disconnect switch connector.
6. Remove parking brake lever.
7. Remove parking brake front cable.
Installation
To install, follow the removal steps in the reverse order, noting the following points:
1. Install parking brake front cable.
2. Install parking brake lever and apply grease (BESCO L-2 or equivalent) to front cable contact point.
3. Reconnect switch connector.
4. Install bolts and tighten the parking brake lever fixing bolt to the specified torque.
Torque: 15 Nm (11 ft. lbs.)
5. Install center console.
6. Install equalizer.
7. Install adjusting nut and adjust the parking brake lever. See "Parking Brake Adjustment" See: Adjustments