VehiCROSS 4WD V6-3.5L (1999)
3. Set push rod gauge J-39216 on vacuum booster, and apply negative pressure by means of vacuum pump J-23738-A so that the pressure in the
vacuum booster becomes 500 mm Hg.
NOTICE: Be sure to apply NEGATIVE pressure after installing a push rod gauge on the vacuum booster.
4. Measure dimension (4).
Dimension (4) (Standard): <-0.1> - 0.1 mm (<-0.0039> - 0.0039 inch)
5. If dimension (4) is out of the standard range, adjust push rod using the Push Rod Support J-39241.
6. Mount plate and seal assembly in vacuum booster front shell. Then install the retainer.
7. Install vacuum booster fixing nut and tighten the specified torque.
Torque: 21 Nm (16 ft. lbs.)
8. Install yoke clevis.
9. Connect vacuum hose and make sure that the arrow on the hose points in the direction of the engine.
10. Install master cylinder.
Overhaul
Vacuum Booster
The vacuum booster cannot be disassembled for repair. Replace a defective vacuum booster with a new one.