VehiCROSS 4WD V6-3.5L (1999)
3. Short the two SRS deployment harness leads together by fully seating one banana plug into the other. SRS deployment harness shall remain
shorted and not be connected to a power source until the air bag is to be deployed.
4. Connect the appropriate pigtail adapter to the SRS deployment harness.
5. Remove the driver air bag assembly from vehicle.
WARNING: WHEN STORING A LIVE AIR BAG ASSEMBLY OR WHEN LEAVING A LIVE AIR BAG ASSEMBLY
UNATTENDED ON A BENCH OR OTHER SURFACE, ALWAYS FACE THE AIR BAG AND TRIM COVER UP AND AWAY
FROM THE SURFACE. THIS IS NECESSARY SO THAT A FREE SPACE IS PROVIDED TO ALLOW THE AIR BAG TO EXPAND
IN THE UNLIKELY EVENT OF ACCIDENTAL DEPLOYMENT. FAILURE TO FOLLOW PROCEDURES MAY RESULT IN
PERSONAL INJURY.
6. Clear a space on the ground about 183 cm (6 feet) in clearance where the driver air bag assembly is to be deployed. A paved, outdoor location
where there is no activity is preferred. If an outdoor location is not available, a space on the shop floor where there is no activity and sufficient
ventilation is recommended. Ensure no loose or flammable objects are within the deployment area.
7. Place the J-41497 on the bench vice. This is necessary to provide sufficient stabilization of the fixture during deployment.
8. Attach the Driver air bag assembly in the J-41497. Air bag assembly must be mounted such that the bag will deploy upward. SECURELY
HAND-TIGHTEN ALL FASTENERS PRIOR TO DEPLOYMENT.
9. Extent double pole extension cord to a position for away 10m (33 feet) from the air bag assembly.
