VehiCROSS 4WD V6-3.5L (1999)
G Sensor, ABS: Service and Repair
Removal
1. Remove center console.
2. Remove clip (1) from G-sensor connector (2), then disconnect connector.
3. Remove G-sensor fixing screw (4).
4. Remove G-sensor (3).
Inspection and Repair
Refer to "Chart B-5." See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and
Associated Procedures/Manufacturer Code Charts/Antilock Brake System/B-5
Installation
1. Install G-sensor assembly (3).
^
Care should be taken so that the G-sensor is not installed in the wrong direction.
2. Install G-sensor assembly fixing screw (4).
^
Tighten the fixing screw to the specified torque.
Torque: 6 Nm (52 inch lbs.)
3. Install G-sensor wiring connector (2) and clip (1).
4. Install center console.