VehiCROSS 4WD V6-3.5L (1999)
27.
Remove and discard the retaining (snap) ring (see figure 14).
28.
Remove the compressor tool and spring seat. Discard the spring seat.
29.
Remove the reverse piston. Discard the inner & outer 0-rings (see figure 15).
30.
Remove the center support bolts.
31.
Remove the center support housing from the adapter case (see figure 16).
32.
Use a plastic hammer if necessary.
IMPORTANT:
The separator plate gaskets will look deformed and are the primary internal leak. If both gaskets are flat, in-place and not torn STOP, replacing
them will not repair the complaint.
NOTE:
Follow normal transmission replacement procedure for warrantable cases.