VehiCROSS 4WD V6-3.5L (1999)
2. Tap out the needle roller bearing by gently striking the shoulder of the yoke, using a mallet or a brass hammer.
3. Make sure of proper position for reinstallation by applying setting marks, then remove spider with grease fitting.
Inspection and Repair
Make necessary correction or parts replacement if wear, damage, corrosion or any other abnormal condition is found through inspection.
Notice: When any part of the journal assembly (spider, needle roller bearing, grease fitting) requires replacement, be sure to replace the entire
assembly.
Check the following parts for wear, damage, noise or any other abnormal conditions:
1. Spider
2. Needle roller bearing
3. Yoke
4. Flange
Outside Diameter of Spider Pin
Standard: 17.00 mm (0.669 inch)
Limit: 16.90 mm (0.665 inch)