S-Type (X200) V8-4.2L (2005)
/v8-4.2l/Page-1053002.png)
8. Remove the HCU.
Installation
1. Install the HCU.
^
Tighten to 9 Nm.
2. Connect the HCU electrical connector.
3. CAUTION: If brake fluid is spilt on the paintwork, the effected area must be immediately washed down with cold water.
Attach the HCU brake tubes.
^
Tighten to 17 Nm.
4. Connect the battery ground cable.
5. Bleed the ABS brake system.
