S-Type (X200) V8-4.2L (2005)
/v8-4.2l/Page-1054001.png)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Hydraulic Control Unit (HCU) - VIN Range: N52207->N99999
Hydraulic Control Unit (HCU) - VIN Range: N52207->N99999 (70.60.18)
Special Service Tools
Removal
All vehicles
1. WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with the eyes. Wash hands thoroughly after handling,
as prolonged contact may cause irritation and dermatitis. If brake fluid contacts the eyes, flush the eyes with cold water or eyewash
solution and seek medical attention. If taken internally do not induce vomiting, seek immediate medical attention. Failure to follow these
instructions may result in personal injury.
NOTE: To prevent the loss of brake fluid, apply the brake pedal hold-down tool and adjust to hold the brake pedal down 60 mm (2.4 inch).
Disconnect the battery ground cable.
2. Raise and support the vehicle.
3. Connect brake bleed pipes and bottles to the left-hand front and the left-hand rear brake caliper bleed nipples and loosen the brake caliper bleed
nipples.
4. Install pedal hold-down tool.
^
Install the tool between the brake pedal and the seat frame.
^
Turn the tool hand-wheel to press and hold the brake pedal 60 mm (2.4 inch) from the "Off" position
^
This will prevent loss of fluid from the reservoir through disconnected brake tubes.
Vehicles with standard brakes
1. Remove the bleed pipes and bottles.
^
Tighten the left-hand front caliper bleed nipple.
-
Tighten to 8 Nm.
^
Tighten the left-hand rear brake caliper bleed nipple.
-
Tighten to 14 Nm.
^
Disconnect and remove the brake bleed pipes and bottles.
^
Install the bleed nipple dust caps.
Vehicles with high performance brakes
1. Remove the bleed pipes and bottles.
^
Tighten the left-hand front caliper bleed nipple.
-
Tighten to 14 Nm.
^
Tighten the left-hand rear brake caliper bleed nipple.
-
Tighten to 14 Nm.
^
Disconnect and remove the brake bleed pipes and bottles.
^
Install the bleed nipple dust caps.
All vehicles
