S-Type (X200) V8-4.2L (2005)
/v8-4.2l/Page-391005.png)
12. Remove the camshaft bearing caps.
^
Remove the camshaft bearing cap retaining bolts evenly and in stages.
^
Remove the camshaft bearing caps. Note their orientation and markings, each is marked with its position (a number) and orientation (an
arrow).
13. Remove the right-hand intake camshaft.
Installation
All vehicles
1. NOTE: Make sure all components are clean.
Apply oil (EP-90) to the camshaft and bearing surfaces, as follows:
^
To the upper face of each bearing surface in the cylinder head.
^
To the upper face of each bearing surface in each bearing cap.
^
On the cam lobes ONLY, not on the base circle area.
2. Install the right-hand inlet camshaft.
