S-Type (X200) V8-4.2L (2005)
3. CAUTION: Alternate bolt tightening to correctly seat the camshaft bearing caps.
Install the camshaft bearing cap bolts evenly.
^
Tighten to 10 Nm.
4. NOTE: Make sure all components are clean.
Apply oil (EP-90) to the camshaft and bearing surfaces, as follows:
^
To the upper face of each bearing surface in the cylinder head.
^
To the upper face of each bearing surface in each bearing cap.
^
On the cam lobes ONLY, not on the base circle area.
5. Install the right-hand exhaust camshaft.
6. CAUTION: Alternate bolt tightening to correctly seat the camshaft bearing caps.
Install the camshaft bearing cap bolts evenly.
^
Tighten to 10 Nm.