S-Type (X200) V8-4.2L (2005)
6. NOTE: Check crankshaft pulley and locking ring for damage.
Clean all crankshaft pulley mating faces.
Installation
All vehicles
1. Install a new crankshaft front seal.
2. Install a new O-ring seal to the crankshaft pulley.
^
Lubricate the new O-ring seal.
3. CAUTION: The screw thread in the crankshaft must be cleaned out before a new crankshaft pulley retaining bolt is installed. Failure to follow
this instruction may result in damage to the vehicle.
CAUTION: A new crankshaft pulley retaining bolt must be used. Failure to follow this instruction may result in damage to the vehicle.
Loosely install a new crankshaft pulley retaining bolt.
^
Install the crankshaft pulley and locking ring to the crankshaft.
4. CAUTION: Under no circumstances should the special tool 303-645 be used in the following operations to lock the crankshaft. Failure to follow
this instruction may result in damage to the vehicle.
Using special tools, retain the crankshaft pulley.
^
Tighten the crankshaft pulley retaining bolt to 320 Nm.
5. Remove the special tools.
Vehicles without supercharger
1. Raise the vehicle.