S-Type (X200) V8-4.2L (2005)
Installation
All vehicles
1. Install new seals to the timing cover.
^
Install the new seal to the inner groove on the face of the timing cover.
^
Install the new seal to the outer groove on the face of the timing cover.
2. Apply sealant to the eight joints on the engine face.
^
Sealant beads to be 3 mm diameter and 12mm long. Cut the nozzle of the sealant tube to produce a 3 mm (0.12 inch) bead. (Install and tighten
the securing bolts within twenty minutes of sealant application).
3. Install the timing cover.
^
Tighten in the sequence shown.
^
Tighten to 13 Nm.