S-Type (X200) V8-4.2L (2005)
-
This procedure involves fuel handling. Be prepared for fuel spillage at all times and always observe fuel handling precautions. Failure to follow
these instructions may result in personal injury.
-
If taken internally do not induce vomiting, seek immediate medical attention. Failure to follow these instructions may result in personal injury.
-
If fuel contacts the eyes, flush the eyes with cold water or eyewash solution and seek medical attention.
-
Wash hands thoroughly after handling, as prolonged contact may cause irritation. Should irritation develop, seek medical attention.
CAUTION:
-
On vehicles with supercharger make sure the arrow on the fuel pump module and the 'SC' marker on the fuel tank are aligned.
-
On vehicles without supercharger make sure the arrow on the fuel transfer module and the 'NA' marker on the fuel tank are aligned.
-
Make sure no damage occurs to the fuel level float.
NOTE:
-
Install a new gasket to the fuel pump module flange.
-
Take care not to stretch the gasket.
1. Install the fuel pump module.
-
Feed the fuel cross-over lines through the fuel pump module hole and across the front of the fuel tank saddle.
2. Using the special tool, install the fuel pump module locking ring.
-
Tighten to 60 Nm.
3. Connect the fuel pump module electrical connector.
4. Attach the fuel pump module electrical connector to the retaining bracket.