S-Type (X200) V8-4.2L (2005)
/v8-4.2l/Page-726003.png)
-> Yes
INSTALL a new ABS module, or DSC module. CLEAR the DTC. TEST the system for normal operation.
-> No
G195523t10 : CHECK CONTINUITY OF THE CAN + CIRCUIT
1. Turn the ignition switch to the OFF position.
2. Disconnect the battery negative terminal.
3. Disconnect the ECM electrical connector, PI001, and the IC connector, FC015.
4. Measure the resistance between PI001, pin 124 (Y) and FC015, pin 018 (Y).
-
Is the resistance less than 5 ohms?
-> Yes
-> No
REPAIR the CAN + circuit between PI001, pin 124 and FC015, pin 017. CLEAR the DTC. TEST the system for normal operation.
G195523t11 : CHECK CONTINUITY OF THE CAN - CIRCUIT
1. Turn the ignition switch to the OFF position.
2. Disconnect the battery negative terminal.
3. Measure the resistance between PI001, pin 123 (G) and FC015, pin 019 (G).
-
Is the resistance less than 5 ohms?
-> Yes
-> No
REPAIR the CAN + circuit between PI001, pin 123 and FC015, pin 019. CLEAR the DTC. TEST the system for normal operation.
G195523t12 : CHECK FOR LOSS OF TERMINATION WITHIN THE ECM
1. Turn the ignition switch to the OFF position.
2. Disconnect the battery negative terminal.
3. Measure the resistance between pins 123 and 124 of the ECM.
-
Is the resistance between 100 and 140 ohms?
-> Yes
-> No
INSTALL a new ECM. CLEAR the DTC. TEST the system for normal operation. Before replacing a ECM, contact Dealer technical support.
G195523t13 : CHECK FOR LOSS OF TERMINATION WITHIN THE INSTRUMENT CLUSTER
1. Turn the ignition switch to the OFF position.
2. Disconnect the battery negative terminal.
3. Measure the resistance between pins 018 and 019 of the instrument cluster.
-
Is the resistance between 100 and 140 ohms?
-> Yes
Possible intermittent fault. Recheck DTCs. Repeat tests from A1.
-> No
INSTALL a new instrument cluster. CLEAR the DTC. TEST the system for normal operation.
Electronic Park Brake (EPB) Module
B : THE MODULE DOES NOT RESPOND TO THE JAGUAR APPROVED DIAGNOSTIC TESTER - ELECTRONIC PARK BRAKE (EPB)
MODULE
