S-Type (X200) V8-4.2L (2005)
-> No
G195523t210 : CHECK K-LINE FOR SHORT CIRCUIT TO BATTERY
1. Turn the ignition switch to the OFF position.
2. Disconnect the battery negative terminal.
3. Measure the resistance between diagnostic connector FC001 pin 7 (K-line) and pin 016, BATTERY.
-
Is the resistance less than 5 ohms?
-> Yes
REPAIR the circuit. CLEAR the DTC. TEST the system for normal operation.
-> No
G195523t211 : CHECK FOR OPEN CIRCUIT ON K-LINE BETWEEN DIAGNOSTIC CONNECTOR AND HID MODULE
1. Turn the ignition switch to the OFF position.
2. Disconnect the battery negative terminal.
3. Disconnect the ADHLS module electrical connector, FH012.
4. Measure the resistance between diagnostic connector FC001 pin 7 (W). (K-line) and FH12, pin 5 (W).
-
Is the resistance less than 5 ohms?
-> Yes
INSTALL a new ADHLS module. CLEAR the DTC. TEST the system for normal operation.
-> No
REPAIR the circuit. CLEAR the DTC. TEST the system for normal operation.
Parking Aid
H : THE MODULE DOES NOT RESPOND TO THE JAGUAR APPROVED DIAGNOSTIC TESTER - PARKING AID
G195523t212 : CHECK REVERSE PARK AID MODULE FOR DAMAGE
1. INSPECT the parking aid module for damage.
-
Does the parking aid module indicate signs of damage?
-> Yes
INSTALL a new parking aid module. CLEAR the DTC. TEST the system for normal operation.
-> No
G195523t213 : CHECK K-LINE FOR SHORT CIRCUIT TO GROUND
1. Turn the ignition switch to the OFF position.
2. Disconnect the battery negative terminal.
3. Measure the resistance between diagnostic connector FC001, pin 7 (K-line) and GROUND.
-
Is the resistance less than 5 ohms?
-> Yes
REPAIR the circuit. CLEAR the DTC. TEST the system for normal operation.
-> No
G195523t214 : CHECK K-LINE FOR SHORT CIRCUIT TO BATTERY
1. Turn the ignition switch to the OFF position.
2. Disconnect the battery negative terminal.
3. Measure the resistance between diagnostic connector FC001, pin 7 (K-line) and pin 016, BATTERY.
-
Is the resistance less than 5 ohms?