S-Type (X200) V8-4.2L (2005)
5. Detach the air bag and chute assembly from the instrument panel.
-
Remove the air bag chute retaining bolts.
-
Detach the air bag and chute assembly from the instrument panel.
6. Detach the wiring harness.
NOTE: Right-hand shown, left-hand similar.
7. Remove the passenger air bag and chute assembly.
-
Disconnect the passenger air bag electrical connectors.
8. Remove the passenger air bag from the chute.
Installation
WARNING:
-
An RCM module only requires replacement if the system has incurred five separate deployments. At no time change an RCM for less
than five separate deployments.
-
Always wear safety glasses when repairing an air bag SRS vehicle and when handling an air bag module. Failure to follow this
instruction may result in personal injury.
-
Carry a live air bag module with the air bag and deployment door pointed away from your body. This will reduce the risk of injury in the
event of an accidental deployment.
-
Never probe the connectors on the air bag module. Doing so may result in air bag deployment. Failure to follow this instruction may
result in personal injury.