S-Type (X200) V8-4.2L (2005)
/v8-4.2l/Page-1031005.png)
2. Attach the driveshaft to the rear drive axle flange.
^
Tighten to 88 Nm.
3. Attach the driveshaft to the transmission flange.
^
Tighten to 108 Nm.
4. CAUTION: Make sure the driveshaft centre bearing is correctly aligned to the driveshaft. Failure to follow these instructions may result in
damage to the vehicle.
Carry out the Driveline Angle Inspection
