Vanden Plas (X308) V8-4.0L (AJ27) (2000)
/v8-4.0l_(aj27)/Page-1167014.png)
45. Ensuring graduation mark remains aligned, finally tighten wishbone front eccentric bolt to 113 - 153 Nm.
46. Install air intake tube/meter/ cleaner cover assembly.
47. Install both engine covers (normally aspirated vehicles only).
Position covers over engine.
Install securing pegs.
48. Fill power steering system.
49. Remove fender covers and close hood.
50. Connect ground cable to battery terminal and fit battery cover. Refer 86.15.19.
51. Carry out steering geometry and wheel alignment checks and adjust as necessary.
