Vanden Plas (X308) V8-4.0L (AJ27) (2000)
7. Where fitted, install fuel vapor pipe to subframe bolts.
8. Tighten subframe center to differential casing bolts to 88-118 Nm.
9. Position spacer in the recess of each subframe bush.
10. Raise jack to locate subframe bushes on the body tapered locations.
11. CAUTION: When installing subframe bracket ensure that wheel speed sensor harness is clear.
Fit suspension subframe mounting-brackets.
1. Position bracket to subframe.
2. Install but do not tighten bush center bolt.
3. Install but do not tighten bolts securing bracket to body.
-
Following same procedure, install mounting bracket on opposite side.