Vanden Plas (X308) V8-4.0L (AJ27) (2000)
1. Position hinge on console lid and fit and tighten securing screws.
2. Position glovebox lid on centre console and fit and tighten securing screw.
3. Fully seat liner in centre console and fit and tighten rear securing screws.
4. Fit glovebox latch to liner and fit and tighten securing screws.
5. Position glovebox to lid stay, fit and tighten securing screw and close glovebox lid.
Overhead Console
Overhead Console (76.13.69)
Removal
1. Remove battery cover and disconnect ground cable from battery terminal.
2. Open roof console sun glasses compartment.
3. Rotate fastener 1/4 turn to release console.
4. Lower console from roof and disconnect lighting module harness multiplug and hands-free microphone harness multiplug if telephone is fitted.
5. Release roof console from retaining clips and remove from vehicle.
Installation
1. Position roof console at headlining and connect lighting harness multiplug and hands-free microphone multiplug if fitted.
2. Engage console in retaining clips.
3. Aligning with headlining aperture, seat console and rotate fastener 1/4 turn to secure.