Vanden Plas (X308) V8-4.0L (AJ27) (2000)
Brake Pad: Service and Repair
Rear
Standard Brakes
Removal
WARNING: BRAKE DUST, IF INHALED CAN DAMAGE YOUR HEALTH. ALWAYS REMOVE BRAKE DUST USING A
VACUUM BRUSH. DO NOT USE A COMPRESSED-AIR LINE TO DISPERSE BRAKE DUST INTO THE ATMOSPHERE.
CAUTION: Replacement of nuts and bolts: Various thread-locking devices are used on nuts and bolts throughout the vehicle. These devices
restrict the number of times a nut or bolt can be used.
1. Open engine compartment and fit paint work protection covers to fenders.
2. Raise rear of vehicle and support on stands.
3. Remove both rear wheels.
4. CAUTION: Remove brake fluid spillage immediately from paint work, with clean water.
Loosen brake fluid reservoir-cap.
Position a cloth around the reservoir to collect any fluid spillage.
5. CAUTION: Tie caliper housing aside. Do not allow the caliper housing to hang on the hydraulic hose, as this will damage the hose.
Remove caliper housing from caliper carrier.
Remove anti-rattle spring.
Remove dust covers.