Vanden Plas (X308) V8-4.0L (AJ27) (2000)
Remove guide pins.
Remove housing from carrier.
Tie caliper housing aside.
6. NOTE: The inner brake pad is fitted with a clip which secures the pad into the caliper piston.
Remove brake pads from caliper housing.
Discard brake pads.
7. Clean all mating surfaces and remove brake dust. See Warning above.
8. Repeat above procedure to remove opposite side brake pads.
Installation
1. CAUTION: Retracting the caliper piston may cause the fluid reservoir to over-flow. Remove brake fluid spillage immediately from paint work,
with clean water.
Slowly retract piston into caliper housing.