Vanden Plas (X308) V8-4.0L (AJ27) (2000)
/v8-4.0l_(aj27)/Page-283004.png)
2. Install the securing screws to the cam covers.
Install a new sealing ring to each screw assembly
Install the screws to the cam covers.
Each screw is retained by the cam cover gasket.
Refer to the tightening sequence diagram for details of where to install the studs.
3. Apply RTV sealant WSS-M4G320-A3 to two places on the joint between the timing cover and the cylinder head.
The application of sealant must be 3 mm diameter by 12 mm long.
Install the cam cover immediately after applying the sealant.
The cover should be installed directly to the head without smearing the sealant.
4. Install the cam cover.
Position the cam cover onto the cylinder head without smearing the sealant and start the threads of each securing screw.
