Vanden Plas (X308) V8-4.0L (AJ27) (2000)
/v8-4.0l_(aj27)/Page-336011.png)
21. Install the drive belt to the generator and accessory drive.
Locate the belt around the pulleys, except the generator pulley.
Use a spanner e.g. Churchill JD-230 or Snap On XDHM 1415, on the center bolt of the belt tensioner idler pulley, to turn the adjuster assembly to
the left against spring tension.
Whilst holding the tensioner against spring tension, connect the drive belt to the generator pulley.
Release the tensioner slowly and remove the spanner.
22. Tighten the three screws which secure the water pump pulley, to 10 - 14 Nm.
23. Connect the top hose to the coolant outlet pipe.
Connect the top hose. Reposition the hose clip and tighten.
24. Connect the radiator top hose.
Connect the hose to the radiator.
Reposition the clip along the hose and tighten the clip.
25. Reset the engine compartment cover to the normal position and connect the gas struts.
26. Connect the battery and install the battery cover.
27. Refill the cooling system.
28. Remove the paintwork protection sheets and close the engine compartment.
