Vanden Plas (X308) V8-4.0L (AJ27) (2000)
11. Using special pliers, remove and discard the inboard circlip from the vertical link.
12. Using special pliers, remove and discard outboard circlip from the vertical link.
13. NOTE: Ensure the vertical link is level, and the supports are situated as near to the bearing bore as possible.
Using a hydraulic press, remove wheel bearing from the vertical link.
Position the vertical link so that the inboard side of the bearing bore is resting on suitable supports on the press-bed.
Position special tool 204-197 on top of bearing.
Operate press to remove bearing from vertical link, discard bearing.
14. Clean relevant parts.
Installation