Vanden Plas (X308) V8-4.0L (AJ27) (2000)
/v8-4.0l_(aj27)/Page-232015.png)
20. To prevent damage to lower ball joint, secure vertical link to road spring using strong wire.
21. CAUTION: Do not use special tool 211-098 in the following procedure as this will damage the ball joint gaiter.
Release lower wishbone ball joint from vertical link/hub assembly.
Install special tool 204-192 on ball joint.
Tighten tool bolt to release ball joint taper pin from vertical link.
22. Remove vertical link/bearing assembly.
23. Remove special tool 204-192.
24. Clean all suspension to vertical link/hub assembly mating surfaces.
25. Repeat procedure steps 2 to 24 on opposite side of vehicle.
Installation
