Vanden Plas (X308) V8-4.0L (AJ27) (2000)
Using a drift, remove thrust washer and spacer tube from each inner and outer half-bush.
Remove inner and outer half bushes from wishbone.
Repeat procedure to remove remaining bush assembly.
18. Clean wishbone paying particular attention to bush locations.
19. Check that ball joint gaiter is not punctured or deeply abraded.
Installation
1. Install thrust washer and spacer tube in first wishbone half-bush
2. Apply a suitable lubricant to exterior of each half-bush.
3. Install soft covers to vise jaws.