Vanden Plas (X308) V8-4.0L (AJ27) (2000)
/v8-4.0l_(aj27)/Page-619002.png)
7. CAUTION: Under no circumstances remove the driveshaft to flexible coupling fixings.
Detach the driveshaft from the transmission unit.
Mark the position of the coupling to drive flange.
Remove the three bolts which secure the transmission drive flange to the flexible coupling.
8. Remove the rear extension housing assembly.
Remove the ten bolts, noting their location for installation.
Remove and discard the O-ring.
9. Clean the mating faces.
Installation
1. Installation is the reverse of the removal procedure noting that;
Install a new O-ring seal.
Tighten the ten bolts to the specified torque figure.
