XJ-6 L6-4.2L (1983)
FIGURE 1
7.
Position the stainless steel trim into the sealer - fit the new outer plastic finisher holding the stainless steel trim in position with masking tape.
(Fig. 1)
8.
When the stainless trim is firm in the Urethane E, remove the masking tape and fit the inner plastic finisher. (Fig. 1)
9.
Thoroughly clean windshield and remove all traces of excess Urethane material.
10.
Test for water leaks with a hose. Application of water will help the curing of the Urethane E material.
