jaguar Workshop Repair Guides

Jaguar Workshop Service and Repair Manuals

Interior Moulding / Trim|Console > < Powder Cleaning - Removal of Small Spillage Stains|Page 4422
Page 1
background image

Carpet: Service and Repair
Spot Cleaning - Localized Stains

Localized stains caused by accidental spillage may be one of three types:

-

Water based stains caused by foodstuffs, starches, sugars, soft drinks, fruit stains, washable ink etc. These stains adhere readily to the pile and do
not respond to vacuum cleaning. They are best removed immediately using the procedure detailed below.

-

Oil/grease based stains caused by spillage or other contamination by butter, grease, hand cream, ball point pen ink, crayon, lipstick etc.

-

A combination of both these types.

To remove water based stains:

-

Blot up liquids and/or scrape oft semi-solids using a spatula.

-

Sponge the affected area with clean luke-warm water. Use a clean, damp, undyed, cotton cloth to absorb as much of the moisture as possible,
working from the edge to the centre of the stain.

-

If the stain persists, apply a suitable carpet shampoo solution made up to the manufacturers instructions, again working from the edge to the centre
of the stain.

-

Rinse with clean, warm water, taking care not to over-wet the carpet.

-

Absorb excess moisture by laying dry, undyed cloths or white paper towels over the moist carpet under light pressure; replace when necessary.

-

When the carpet is thoroughly dry, vacuum clean the area to lift the carpet pile.

CAUTION: When liquids are applied to the pile, use only a clean cloth or sponge. Do not apply liquids directly to the carpet - when attempting
to remove stains, blot the pile as heavy rubbing can destroy the yarn structure of the carpet.

To remove oil/grease based stains:

-

Using a suitable aerosol containing solvent loaded with absorbent powder, spray the affected areas of the carpet. The solvent loosens the grease
from the fibre and the powder then absorbs the grease-carrying solvent.

-

Allow the solvent to evaporate and remove the powder containing the grease by using a vacuum cleaner or brush.

NOTE:  Neat solvent, eg dry cleaning fluid, may be used, but should be used sparingly from a clean white cloth.

CAUTION: Solvents must only be used in well-ventilated areas where naked lights and smoking are prohibited.

To remove stains which are a combination of oil and water based contamination (usually resulting from food or drink):

-

Treat combination stains as for water based stains.

-

Allow to dry out.

-

Treat as for grease based stains.

Interior Moulding / Trim|Console > < Powder Cleaning - Removal of Small Spillage Stains|Page 4422