XJ-Super V8 (X308) V8-4.0L SC (AJ27) (2002)
27.
Install three new dowels to A/C compressor/PAS pump mounting bracket (Illustration 4).
Note:
Using suitable vernier caliper, check that the two dowels locating the A/C compressor/PAS pump mounting bracket to the engine (see 1,
Illustration 4) protrude 4.2-4.8 mm and that the dowel locating the A/C compressor to the bracket (see 2, Illustration 4) protrudes 3.2-3.8 mm.
28.
Seat A/C compressor/PAS pump mounting bracket on the engine.
29.
Install and tighten the upper front bolt securing the A/C compressor/PAS pump mounting bracket to the engine.
30.
Align crank sensor harness support clip to A/C compressor/PAS pump mounting bracket upper rear fixing hole.
31.
Install and tighten the upper rear bolt securing the A/C compressor/PAS pump mounting bracket to the engine.
32.
Reposition and align PAS pump to mounting bracket.
33.
Install and tighten PAS pump securing bolts to 16-20 Nm (Illustration 5).
34.
Install and tighten engine dipstick tube retaining bracket to PAS pump securing bolt to 8-12 Nm.
35.
Position PAS pump pulley and align fixing holes.
36.
Install, but do not tighten, PAS pump pulley securing bolts.
37.
Position special tool 303-D055 on PAS pump pulley and tighten tool belt.
38.
Final tighten PAS pump pulley securing bolts to 18-24 Nm.
39.
Remove special tool 303-D055 from PAS pump pulley and place aside.