XJ-Super V8 (X308) V8-4.0L SC (AJ27) (2002)
18. Slacken but do not remove nut securing lower wishbone ball joint to vertical link.
19. CAUTION:
Do not use special tool 211-098 in the following procedure as this will damage the ball joint gaiter.
Release lower wishbone ball joint from vertical link/hub assembly.
1. Install special tool 204-293 on ball joint.
2. Tighten tool bolt to release ball joint taper pin from vertical link.
20. Remove special tool 204-293 from ball joint.
21
Remove vertical link/hub assembly.
^
Supporting vertical link/ hub assembly, remove lower wishbone ball joint nut.
^
Remove vertical link /hub assembly.
22. Remove stabilizer bar link to wishbone bracket securing nut and bolt.
23. Remove wishbone front arm to rear arm securing bolt .