XJ-Super V8 (X308) V8-4.0L SC (AJ27) (2002)
^
Remove wishbone eccentric bolt and nut.
30. Remove lower wishbone rear arm/ball joint assembly from crossbeam.
31. Remove lower wishbone front arm eccentric bolt and nut.
^
Mark position of eccentric bolt large graduation mark on crossbeam.
^
Remove wishbone front eccentric bolt and nut.
32. Remove lower wishbone front arm from crossbeam.
33. NOTE:
For assembly purposes, note orientation of bush.
NOTE:
Initial press action will cause tool to shear bush flange.
Using a hydraulic press, remove bush from wishbone front arm.
1. Position arm on suitable supports on press bed.
2. Position Special Tool 204-214 on top of bush.
3. Operate press to remove bush from arm.
34. Remove wishbone front arm from press
35. NOTE:
For assembly purposes, note orientation of bush.
NOTE:
Initial press action will cause tool to shear bush flange.
Using a hydraulic press, remove bush from rear wishbone arm.
1. Position arm on suitable supports on press bed.
2. Position special tool on top of bush.
3. Operate press to remove bush from arm.
Installation
CAUTION:
The wishbone front and rear arm bushes differ in length. Ensure the correct bush is installed in each arm.
1. Using a hydraulic press, install bush in wishbone rear arm/ball joint assembly.
1. Position arm on suitable supports on press bed.