XJ (X350) V8-4.2L (2005)
Rear Bumper Reinforcement: Service and Repair
Bumper Beam Rear - II
Bumper Beam Rear
Panel Drawing
Consumables
None.
Mechanical, Electrical and Trim, remove and install:
Rear exhaust brackets (RH/LH)
(4 x 10 mm bolts)
MET Tools
10 mm socket
3/8" Drive ratchet
Panel Tools
10 mm socket
3/8" Drive ratchet
01. The rear bumper beam is a category B bolt on panel.
Remove MET items as listed.
Complete 'Pre-Repair Activities'.
02. Unbolt beam as indicated (4 x 10 mm bolts).
NOTE: Bolts are pre-coated to inhibit galvanic corrosion and are reusable-only if coating is undamaged.