XJR (X300) L6-4.0L SC (AJ16) (1995)
Drive Belt: Service and Repair
Supercharger Belt, Tensioner Bracket
SUPERCHARGER DRIVE BELT TENSIONER BRACKET; RENEW
-
Raise the vehicle on a ramp.
-
Remove the supercharger drive belt.
-
Remove the drive belt tensioner pulley from the tensioner bracket.
-
Remove the bolts securing the tensioner bracket (5 Fig. 1) to the adapter casting.
-
Release the bolt securing the tensioner bracket to the water pump and remove the bracket, bolt and distance piece.
-
Remove the securing bolt and distance piece from the bracket.
-
Remove the pulley carrier and adjusting bolt from the bracket and discard the bracket.
-
Fit the pulley carrier and adjusting bolt to a new tensioner bracket.
-
Fit the water pump securing bolt and distance piece to the tensioner bracket.
-
Position the tensioner bracket, bolt and distance piece. Fit, but do not tighten, the securing bolt.
-
Fit and tighten the bolts securing the tensioner bracket to the adapter casting.
-
Finally tighten the bolt securing the tensioner bracket to the water pump.
-
Fit the drive belt tensioner pulley to the tensioner bracket.
-
Fit the supercharger drive belt.
-
Lower the vehicle on the ramp.