XJR (X300) L6-4.0L SC (AJ16) (1995)
/l6-4.0l_sc_(aj16)/Page-1254001.png)
Valve Body: Service and Repair
Valve Body Assembly, Renew
Valve Body Assembly, Renew
^
Raise hood and fit wing cover.
^
Raise the vehicle on a ramp.
^
Drain the transmission lubrication system.
^
Remove the fluid pan.
^
Remove the fluid filter.
^
Remove the transmission internal harness.
^
Remove the internal lubrication pipe.
^
Remove the manual detent spring assembly.
^
Remove the internal dipstick stop.
^
Remove the valve body and accumulator assembly.
^
Note the internal harness runs for assembly purposes.
^
Disconnect the internal harness plug from 'A' shift solenoid.
^
Disconnect the internal harness plug from 'B' shift solenoid.
^
Disconnect the internal harness plug from the temperature sensor.
^
Disconnect the internal harness plug from the pulse width modulator (TCC solenoid).
^
Disconnect the internal harness plug from the variable force motor and place aside.
^
Release and remove 'A' shift solenoid to valve body securing screw.
^
Invert valve body assembly.
^
Release and remove accumulator block to valve body securing bolts.
^
Remove accumulator block assembly from valve body.
^
Remove and discard accumulator block to sandwich plate gasket.
^
Remove sandwich plate from valve body.
^
Remove and discard sandwich plate to valve body gasket.
^
Clean all relevant parts and faces.
^
Place valve body aside.
^
Place new valve body - supplied with new valves, solenoids etc - to front.
^
Fit new gasket to valve body.
^
Fit sandwich plate to valve body.