XK-8 Coupe (X100) V8-4.0L (AJ26) (1998)
-
Remove paper backing from pads to reveal adhesive shim.
-
Install brake pads, insert clip located on back of inner pad into caliper piston.
7. Install caliper housing to caliper carrier.
-
Align housing to carrier.
-
Install and tighten guide pins to 25 - 30 Nm.
-
Install dust covers.
-
Install anti-rattle spring.
8. Repeat above procedure to install opposite side brake disc.
9. Fit wheels.
10. Remove stands and lower vehicle.
CAUTION: Remove brake fluid spillage immediately from paint work, with clean water.
11. Check brake fluid level.
-
Check brake fluid level is at the maximum mark.
-
Remove cloth.
-
Fit cap.
12. Remove paint work protection covers, and close engine compartment.
13. Start the engine and repeatedly press the brake pedal until brake pressure is evident.
Brembo Brakes